Hello Wrenches, I am trying to figure out a tricky problem. I have a customer with a Mate 3s, most current firmware 1.4.7 paired with a radian and a couple of FM60s and some Lithium batteries. We have experienced partial data loss, particularly of the Mate 3s generator start parameters. These parameters seem to go back to defaults and it defaults to an AGS disabled state.
At first I thought it was due to electrical storms, because we've had quite a bit of lightning lately, but now I'm not sure. The Cat6 run is about 80' or something like that, so it could be some induction. Anyone seen anything like this? Same parameters were lost from first data loss to following data loss. Kind of strange. I haven't visited the site so I may not b getting the full picture. Thanks -- Mac Lewis *"Yo solo sé que no sé nada." -Sócrates*
_______________________________________________ List sponsored by Redwood Alliance Pay optional member dues here: http://re-wrenches.org List Address: RE-wrenches@lists.re-wrenches.org Change listserver email address & settings: http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org There are two list archives for searching. When one doesn't work, try the other: https://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/ http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org List rules & etiquette: http://www.re-wrenches.org/etiquette.htm Check out or update participant bios: http://www.members.re-wrenches.org
