Hi Jason, You bring up a valid point….in an off-grid scenario with the 15k do you size the conductors to the continuous capacity, surge capacity or the OCPD of the unit?
-Chris On Fri, Apr 15, 2022 at 4:01 PM Jason Szumlanski via RE-wrenches < re-wrenches@lists.re-wrenches.org> wrote: > P.S. ICYMI, this inverter has a massive combined AC coupled and DC coupled > capacity. They allow 15kWdc plus 19.2kWac!!! Impressive. > > > > > > > On Fri, Apr 15, 2022 at 10:59 AM Jason Szumlanski < > ja...@floridasolardesigngroup.com> wrote: > >> I'm not following the wiring diagrams for this new inverter. It has 200A >> pass-through capability with an integrated 200A load disconnect. But then >> it says the wire gauge for the load out wiring can be #4 to 2/0. >> >> In an off-grid scenario where there is no generator, the max continuous >> output is 62.5A, so I assume 80A circuit protection could be used with 80A >> rated wire (#4), but how is that circuit protection implemented if the 200A >> breaker is integrated? Do you have to run a short piece of 2/0 to an >> external 80A rated OCPD and then step down to #4? >> >> Jason Szumlanski >> >> >> >> >> >> _______________________________________________ > List sponsored by Redwood Alliance > > Pay optional member dues here: http://re-wrenches.org > > List Address: RE-wrenches@lists.re-wrenches.org > > Change listserver email address & settings: > http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org > > There are two list archives for searching. When one doesn't work, try the > other: > https://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/ > http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org > > List rules & etiquette: > http://www.re-wrenches.org/etiquette.htm > > Check out or update participant bios: > http://www.members.re-wrenches.org > > -- Chris Sparadeo C_802-369-4458 H_802-728-3059
_______________________________________________ List sponsored by Redwood Alliance Pay optional member dues here: http://re-wrenches.org List Address: RE-wrenches@lists.re-wrenches.org Change listserver email address & settings: http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org There are two list archives for searching. When one doesn't work, try the other: https://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/ http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org List rules & etiquette: http://www.re-wrenches.org/etiquette.htm Check out or update participant bios: http://www.members.re-wrenches.org
