OK, I'll bite. I use SMA and Outback almost exclusively. SMA for
grid-tie so I can't vouch for SI for Off-grid and I don't seem to have
the same wait problem with SMA, its usually 10-20 minutes.
And Outback.... well they're not perfect but I've been
using there stuff since day 1 (thanks Bob-O), still using FX3524 ser#
0007 and been installing since they were Trace. Service? well, let's
just say it varies but I've been willing to put up with it. The WORST
part of of Outback service calls is the music they pipe in on
'hold'...its enough to make you hang up.
Sol-ark, the new kid on the block sounds slick and I'm
genuinely tempted, specs look great..wonder what their 'hold' music is like?
Bill
Feather River Solar Electric
Bill Battagin, Owner
4291 Nelson St.
Taylorsville, CA 95983
530.284.7849
CA Lic 874049
www.frenergy.net
On 9/9/2020 6:49 PM, Mark Frye wrote:
The most important thing here is that no one is standing up to sing
the praises of either SMA or Outback.
I myself have sent about 2 hours on hold over 2 days trying to get an
issue addressed by SMA.
Re: Sol-Arc I would pay a lot extra or take some not so good aspect in
exchange for good technical support.
On 9/9/2020 1:12 PM, Jason Szumlanski wrote:
Any tips on combining AC output from these units when stacking
several of them? What bus/OCPD system are you using? Same question
for generator/grid input.
The solar MPPT inputs appear to be dead simple.
Jason Szumlanski
--
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
List sponsored by Redwood Alliance
List Address: RE-wrenches@lists.re-wrenches.org
Change listserver email address & settings:
http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
List-Archive: http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org
List rules & etiquette:
www.re-wrenches.org/etiquette.htm
Check out or update participant bios:
www.members.re-wrenches.org
