Kienan:


I have been having the same error messages with a three Radian stack in
off-grid mode.  It was accompanied by a popping sound from one or both of
the power modules and clicking of relays and flickering lights in the home,
and eventually power outage.  Several wrenches suggested a defective power
module.  I replaced the module yesterday and no complaints so far.



Symptoms are a bit different, so I can’t say for sure the problems are
related.



William



Miller Solar

17395 Oak Road, Atascadero, CA 93422

805-438-5600

www.millersolar.com

CA Lic. 773985



*From:* RE-wrenches [mailto:re-wrenches-boun...@lists.re-wrenches.org] *On
Behalf Of *Kienan Maxfield
*Sent:* Friday, September 20, 2019 9:30 PM
*To:* RE-wrenches
*Subject:* [RE-wrenches] Outback Dual Radian System - Phase Loss



Esteemed wrenchers.....



The day before yesterday, I tried to commission a grid-tied system with two
Outback Radians and an Outback FM100. I got an event saying that it had a
phase loss error on Port 2 (which is the slave). I tried looking online and
in the manuals, and I checked all the wiring, but I could not determine the
cause of the problem. It was after hours, so I returned to the site
yesterday and spent 2 hours on the phone with tech support, and I thought I
had finally resolved it, but on Optics, I see that the system was throwing
the same error today. It comes and goes. In my events history, it says
"*Inverter
input on port 2 has lost phase*." then it'll say "*Phase Loss has cleared
on Inverter port 2 input.*"



The interesting thing is that it continues working fine even when it says
the fault is active. It's selling to the grid and everything just as you
would expect it to without interruption. But of course, the flashing red
light is a bit concerning to the customer, and I'm a bit perplexed about it
myself.



Does anybody have any experience with anything like this? Does anybody have
any ideas?



Thank you so much!!

Kienan





*Maxfield Solar*

*maxfieldso...@hotmail.com* <maxfieldso...@hotmail.com>

*(801) 631-5584** (Cell)*
_______________________________________________
List sponsored by Redwood Alliance

List Address: RE-wrenches@lists.re-wrenches.org

Change listserver email address & settings:
http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org

List-Archive: 
http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html

List rules & etiquette:
www.re-wrenches.org/etiquette.htm

Check out or update participant bios:
www.members.re-wrenches.org

Reply via email to