Bill I’m using a Millermatic 212 on a single XW6048 with 16 each PVX3050 AGMs and a 1.4kw array.
It typically draws about 4kw to weld at setting 6 out of 10 (1/8” material thickness) using 0.035 wire. I also have a Spectrum 375 and you can not run them both at the same time with only a 6kw inverter, especially considering the air compressor runs occasionally with the 375. Good luck! Sent from my iPhone > On Dec 11, 2017, at 10:32 AM, frenergy <frene...@psln.com> wrote: > > Anybody done any 240 VAC welding (MIG, wire feed) with a Radian? I've welded > with one of those little 120 VAC Miller MIGs but wondering how a Radian's > 240V would run a larger unit. Other comments about other inverters welcome > too, but currently looking at a Radian for this install. > > Bill > > Feather River Solar Electric > Bill Battagin, Owner > 4291 Nelson St. > Taylorsville, CA 95983 > 530.284.7849 > CA Lic 874049 > www.frenergy.net > > > --- > This email has been checked for viruses by Avast antivirus software. > https://www.avast.com/antivirus > > > _______________________________________________ > List sponsored by Redwood Alliance > > List Address: RE-wrenches@lists.re-wrenches.org > > Change listserver email address & settings: > http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org > > List-Archive: > http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html > > List rules & etiquette: > www.re-wrenches.org/etiquette.htm > > Check out or update participant bios: > www.members.re-wrenches.org > _______________________________________________ List sponsored by Redwood Alliance List Address: RE-wrenches@lists.re-wrenches.org Change listserver email address & settings: http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org List-Archive: http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html List rules & etiquette: www.re-wrenches.org/etiquette.htm Check out or update participant bios: www.members.re-wrenches.org
