You can also buy roofing granules by the 5 gallon bucket. Keep a few colors in the warehouse and a baggie of each on the truck. Three colors are close enough for just about every roof (gray, light brown, reddish brown around here).
6x6 sheets of 28ga aluminum are very handy for this, and they cost next to nothing. Jason Szumlanski Florida Solar Design Group On Fri, Jan 8, 2016 at 12:39 PM, Benn Kilburn <b...@skyfireenergy.com> wrote: > The aluminum flashing sounds great. > I will fill the holes with sealant, re-insert the nails/screws and then > cover all the screw heads with sealant and smooth it out. > If I can scoop some clean aggregate out of the gutter then I spread it > over the smoothed sealant and it blends in so you don't even see the > sealant (which is black and barely noticeable from the ground anyway) > > I wish more homes around here used ridge vent caps. It would limit the > number of roof vents spread out across the roof. > > Benn Kilburn > SkyFire Energy Inc. > 780-906-7807 > > > On Jan 8, 2016, at 9:02 AM, Dave Tedeyan <dtede...@taitem.com> wrote: > > If the customer is very particular, we'll replace the shingle. But most of > the time we just put in an aluminum flashing under the shingle. > -Dave > > > *--* > > > *Dave Tedeyan* > *Project Engineer* > > *Taitem Engineering, PC* > 109 S. Albany Street, Ithaca, NY 14850 > Voice: (607) 277-1118 x121 > www.taitem.com > > On Fri, Jan 8, 2016 at 10:17 AM, Drake < > drake.chamber...@redwoodalliance.org> wrote: > >> What method do you use to repair the shingles? >> >> Thanks, >> >> Drake >> >> At 09:59 AM 1/8/2016, you wrote: >> >> We use similar anchors. >> >> http://solutions.3m.com/wps/portal/3M/en_US/3M-PPE-Safety-Solutions/Personal-Protective-Equipment/Products/Product-Catalog/~/3M-Reusable-Roof-Anchorage-Device-4000-1-ea-case?N=5158341+8702288+3294529207+4294886062&rt=rud >> >> Most shingle roofs we come across have a ridge cap, so we cannot put it >> over the ridge. >> We used to use RS-10 permanent anchors. They are fairly easy to install, >> but we often have arrays going near the peak of the roof, so once modules >> go on, the anchor gets covered up. >> We just install the 3M ones on the opposite side of the roof, and then >> patch the shingles when we are done. >> >> On a related note, does anyone have a good product to use on a >> trapezoidal (agricultural) metal roof? >> Currently we tie ropes to large trees and/or structural members on the >> opposite side of the roof. >> >> Cheers, >> Dave >> >> >> >> >> *-- Dave Tedeyan* >> Project Engineer >> >> >> *Taitem Engineering, PC *109 S. Albany Street, Ithaca, NY 14850 >> Voice: (607) 277-1118 x121 <http://??> >> www.taitem.com >> >> On Thu, Jan 7, 2016 at 10:53 AM, Will White < william.wh...@rgsenergy.com> >> wrote: >> >> We use the RA-35 on the link you had below. They work really well >> because they only take a few screws. >> >>  >> >> From: RE-wrenches [ mailto:re-wrenches-boun...@lists.re-wrenches.org >> <re-wrenches-boun...@lists.re-wrenches.org>] On Behalf Of Benn Kilburn >> Sent: Wednesday, January 06, 2016 4:20 PM >> To: RE-wrenches < re-wrenches@lists.re-wrenches.org> >> Subject: [RE-wrenches] Temporary Roof Anchors >> >>  >> >> Wrenches, >> >> Of our residential installs, i would guess that at least 80% are done on >> composite asphalt shingle roofs typically ranging from 13 to 33deg pitch. >> The rest are made up of various metal roofs, cedar shake, rubber shingles, >> concrete tile, etc... >> >> Obviously, we require roof anchors for fall protection. Rarely do we >> come across existing homes that have roof anchors already installed. >> >> I have typically been using these... >> hinged roof anchor >> <https://www.acklandsgrainger.com/AGIPortalWeb/WebSource/ProductDisplay/globalProductDetailDisplay.do?item_code=DBIAJ730A> >> >> or these... >> RA15-1/ >> <https://www.millerfallprotection.com/fall-protection-products/roofing-products/temporary-roof-anchors> >> >> Preferably the RA15-1 since it can use screws (#12's) instead of nails >> and only needs 8 screws compared to the 20 nails for the hinged anchor... >> ***in order for it to be approved*** >> >>  >> >> ​What are you all using as temporary anchors specifically for asphalt >> shingle roofs​??? >> >> Do any of you prefer to install permanent roof anchors, now that you have >> just installed a "serviceable" piece of equipment on the roof? What do >> you use? >> >> Benn >> >>  >> >> _______________________________________________ >> List sponsored by Redwood Alliance >> >> List Address: RE-wrenches@lists.re-wrenches.org >> >> Change listserver email address & settings: >> http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org >> >> List-Archive: >> http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html >> >> List rules & etiquette: >> www.re-wrenches.org/etiquette.htm >> >> Check out or update participant bios: >> www.members.re-wrenches.org >> >> >> >> _______________________________________________ >> List sponsored by Redwood Alliance >> >> List Address: RE-wrenches@lists.re-wrenches.org >> >> Change listserver email address & settings: >> http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org >> >> List-Archive: >> http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html >> >> List rules & etiquette: >> www.re-wrenches.org/etiquette.htm >> >> Check out or update participant bios: >> www.members.re-wrenches.org >> >> >> <https://www.avast.com/sig-email?utm_medium=email&utm_source=link&utm_campaign=sig-email&utm_content=emailclient> >> This >> email has been sent from a virus-free computer protected by Avast. >> www.avast.com >> <https://www.avast.com/sig-email?utm_medium=email&utm_source=link&utm_campaign=sig-email&utm_content=emailclient> >> >> _______________________________________________ >> List sponsored by Redwood Alliance >> >> List Address: RE-wrenches@lists.re-wrenches.org >> >> Change listserver email address & settings: >> http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org >> >> List-Archive: >> http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html >> >> List rules & etiquette: >> www.re-wrenches.org/etiquette.htm >> >> Check out or update participant bios: >> www.members.re-wrenches.org >> >> >> > _______________________________________________ > List sponsored by Redwood Alliance > > List Address: RE-wrenches@lists.re-wrenches.org > > Change listserver email address & settings: > http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org > > List-Archive: > http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html > > List rules & etiquette: > www.re-wrenches.org/etiquette.htm > > Check out or update participant bios: > www.members.re-wrenches.org > > > _______________________________________________ > List sponsored by Redwood Alliance > > List Address: RE-wrenches@lists.re-wrenches.org > > Change listserver email address & settings: > http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org > > List-Archive: > http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html > > List rules & etiquette: > www.re-wrenches.org/etiquette.htm > > Check out or update participant bios: > www.members.re-wrenches.org > > >
_______________________________________________ List sponsored by Redwood Alliance List Address: RE-wrenches@lists.re-wrenches.org Change listserver email address & settings: http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org List-Archive: http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html List rules & etiquette: www.re-wrenches.org/etiquette.htm Check out or update participant bios: www.members.re-wrenches.org