Ditto Tom, seen this too often in Mexico. I carry a manometer to make check the pressure at the LP input to the generator with the engine running. Make sure it is at/above 11" WC when it starts to act up. If the regulator is at the tank, long vapor runs can cause too much pressure loss.
Larry On Feb 17, 2014, at 1:36 PM, Tom Duffy <t...@thesolar.biz> wrote: Hi Guys We have had “icing” problems here in Central America as well where the gas company put in ½’ pipe to a 12K Gillette Generator, same description the gen would initially start and run fine but then it went erratic the Radian didn’t like it, the customer wanted to blame the Radian (I was sure it wasn’t) The installer/dealer couldn’t figure it out. I went out and immediately saw the small pipe, plus they had bent a crimp into the incoming fuel line as well. ¾” line fixed the whole thing. LP has a lot of moisture and will always have delivery problems with funky installation of pipe. Seems that a lot of gas guys just hook up kitchen ranges (Here) Kind regards Tom Duffy Senior Solar Design Engineer <image002.png> E-Mail: t...@thesolar.biz Panama Office: 507-6126-1253 Direct Toll Free: 888-503-6772 International: 575-539-2111 SKYPE Address: thesolarbiz Although no trees were killed in the sending of this message, a large number of electrons were terribly inconvenienced. Confidentiality Notice: This message including any attachments is for the sole use of the intended recipient and may contain confidential and privileged information. Any unauthorized review, use, disclosure or distribution is prohibited. If you are not the intended recipient, please contact the sender and delete any copies of this message.
_______________________________________________ List sponsored by Home Power magazine List Address: RE-wrenches@lists.re-wrenches.org Change email address & settings: http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org List-Archive: http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org List rules & etiquette: www.re-wrenches.org/etiquette.htm Check out participant bios: www.members.re-wrenches.org
