I once had a Xantrex DR inverter act goofy when the high voltage fence wire was a few inches from it.
The inverter was hung on the inside of a barn wall and the wire ran across the back of it on the outside of the wall.
If I remember right, the high voltage wire caused the DR to shut off.
I think the problem was cleared up with better grounding of the inverter.

Mark
-------- Original Message --------
Subject: [RE-wrenches] Electric fence, metal buildings, lightning
protection systems
From: "Erika Weliczko" <er...@repowersolutions.com>
Date: Fri, December 06, 2013 8:57 am
To: <re-wrenches@lists.re-wrenches.org>

Anyone had to contend with electric fence installation (AC controller) using a ground rod (not main service) at remote farm building and messing with inverters? And perhaps causing other issues?
 
Of course, this is a metal roof with a lightning protection system (i.e. bare braided copper on roof all the way to rod.)
 
I think we need to redirect the electric fence wire to its own dedicated rods, away from the building that has solar.
 
Insights are appreciated.
 
Thanks,
Erika
 

_______________________________________________
List sponsored by Home Power magazine

List Address: RE-wrenches@lists.re-wrenches.org

Change email address & settings:
http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org

List-Archive: http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org

List rules & etiquette:
www.re-wrenches.org/etiquette.htm

Check out participant bios:
www.members.re-wrenches.org

_______________________________________________
List sponsored by Home Power magazine

List Address: RE-wrenches@lists.re-wrenches.org

Change email address & settings:
http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org

List-Archive: http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org

List rules & etiquette:
www.re-wrenches.org/etiquette.htm

Check out participant bios:
www.members.re-wrenches.org

Reply via email to