Friends:
I need to modify an Eaton 400 amp panelboard for an industrial off-grid
system. I need 3 150 amp 2 pole breakers and a few of the clips used to
connect the bolt-on breakers to the busses ("Provisions," they are called).
I was informed by the Eaton rep that the cost to replace the entire interior
of the panelboard was cheaper than buying a few clips. It was explained
that buying "loose parts" was more expensive than buying an entire bus
system. I just cannot believe this.
Has anyone purchased the clips for Eaton before? Know a good Eaton dealer?
Thanks in advance.
William Miller
_______________________________________________
List sponsored by Home Power magazine
List Address: RE-wrenches@lists.re-wrenches.org
Change email address & settings:
http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
List-Archive: http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org
List rules & etiquette:
www.re-wrenches.org/etiquette.htm
Check out participant bios:
www.members.re-wrenches.org
