Lars
I have been using the Xantrex 600 volt charge controller for 6 months. It
works great. It is controlling 4kW coming in at 350 vdc charging a 48 volt
battery. You need to have the remote to set it up and monitor its output.
David Katz
Sent from my HTC smartphone on the Now Network from Sprint!
----- Reply message -----
From: "lars Ortegren" <l...@cal-solar.com>
To: "re-wrenches@lists.re-wrenches.org" <re-wrenches@lists.re-wrenches.org>
Subject: [RE-wrenches] Xantrex 600v charge controller
Date: Wed, May 16, 2012 12:07 pm
Wrenches,
I’m wondering if here is anybody out there that has installed
any Xantrex 600v charge controllers out there. I looking at a job and thinking
about replacing an MX-60 with a 700 foot pipe run to the array wired with #6
thhn!!!! My understanding is that the further away you get from the battery
voltage, the greater the efficiency loss is within the unit. Outback gives the
curve to show the loss of output at higher voltages, but searching Schneider’s
site I can’t find anything close. It’s either going to be this, or tying a
grid-tied inverter through the Outback output, but doing that would only get me
single stage charging. Has anyone watched these controllers over time?
Monitored its output?
Thanks
Lars Ortegren
Director of Operations
California Solar Electric Company
10141 Evening Star Drive, Suite 6
Grass Valley, CA 95945
http://www.californiasolarco.com/
Phone : (530)274-3671
Fax: (530)274-7518
California C-10 Electical Contractor #779624
NABCEP Certified PV Installer # 091110-89
Certified NABCEP Continuing Education Provider
_______________________________________________
List sponsored by Home Power magazine
List Address: RE-wrenches@lists.re-wrenches.org
Options & settings:
http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
List-Archive: http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org
List rules & etiquette:
www.re-wrenches.org/etiquette.htm
Check out participant bios:
www.members.re-wrenches.org
