Wrenches,
I am trying to configure a Morningstar relay driver and am not sure I have the
setpoints in the right sequence. I have the settings loaded into a file on the
laptop with progressively higher battery voltages triggering more diversion
loads but I'm not sure I have the correct order for this to occur. I started
with channel 2 as the first trigger point and then used channel one as a
second,
or higher battery voltage diversion. Does it matter which channel is used
progressively or will it default to whatever setting regardless of which
channel?
I would like to know I have this thing right so I don't have to field
configure.
Any input is appreciated as I have never used one of these units.
Thanks,
Nathan Jones
Power Source Solar
417 827 0738
_______________________________________________
List sponsored by Home Power magazine
List Address: RE-wrenches@lists.re-wrenches.org
Options & settings:
http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
List-Archive: http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org
List rules & etiquette:
www.re-wrenches.org/etiquette.htm
Check out participant bios:
www.members.re-wrenches.org
