We don't often get to take picture, as the point of failure is hard to find, 
and the entire underground line is just abandoned and a new cable is installed.
Most failures I've seen (not actually seen) were on improperly installed runs, 
done by DIYers.
On the other hand, the majority of underground service in New Mexico is done 
with direct burial Aluminum, and if done correctly (buried deep enough, bedded 
in sand, no rocks), it's not so bad. 
My regular suppliers don't even carry big copper, as the Al is so much cheaper, 
and comes in triplex, and 4 plex cables, but it's dry there.
In Hawaii, you see much more copper, so I think it all depends on the 
conditions, both above and below the ground.

R. Walters
r...@solarray.com
Solar Engineer




On Aug 21, 2010, at 2:48 AM, bob wrote:

> Does anyone have any photos of aluminum wire that has failed? Failures from 
> nicked insulation and such would help.
> I have a debate going with a customer who does not believe that it could 
> cause a failure.
>  
> If you have any digital pics please send them to my address, 
> reelli...@gmail.com instead of to the list.
> I know there are some out there somewhere….
>  
> Thanks,
> Bob Ellison
> _______________________________________________
> List sponsored by Home Power magazine
> 
> List Address: RE-wrenches@lists.re-wrenches.org
> 
> Options & settings:
> http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
> 
> List-Archive: 
> http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org
> 
> List rules & etiquette:
> www.re-wrenches.org/etiquette.htm
> 
> Check out participant bios:
> www.members.re-wrenches.org
> 

_______________________________________________
List sponsored by Home Power magazine

List Address: RE-wrenches@lists.re-wrenches.org

Options & settings:
http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org

List-Archive: http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org

List rules & etiquette:
www.re-wrenches.org/etiquette.htm

Check out participant bios:
www.members.re-wrenches.org

Reply via email to