Correction: it is number 6 to the charge control, and 3/0 or 4/0 to
the batteries.
At 09:40 AM 8/20/2010, you wrote:
boB,
It looks like 3/0 or 4/0. It is a short run.
At 08:09 PM 8/19/2010, you wrote:
Jeff Oldham wrote:
I have seen this on my last 3 MX60 controllers and it is very
frustrating and looks to be a design flaw. I can calibrate the
meters to be accurate at either the Absorb point OR the Float
point but NOT both!! Not only that but the meter calibrations tend
to drift a bit in just a matter of days, just .1V not a big deal
but anymore than that on a 12V sealed battery and it could be an
issue. I spoke w/Outback about this and heard a mumbled "Ahh,
uummm, yeah that is an issue". I'm guessing that you're seeing the
same thing and when you spoke w/your customer again and the meters
all agreed I'll bet it is because the MX was at the "line up
point" of the other meters (just like a broken clock being correct
twice a day!). The only way to live with this is to get the more
important Absorb set point right on and take what you get on the
lower end. It works and is usable but drives customers nuts when
they have additional meters. In my experience the Tri-mets are dead on.
Jeff, what size wire from charge controller to the battery are you
using ?? The bigger the wire, the less the
I*R drop and the less the voltage discrepancy ~should~ be, at
higher currents.
boB
From the Solar, Wind and Hydro powered office of Jeff
Oldham/Regenerative SOLutions
____________________________________________________________
*Notre Dame Certificates*
100% Online Programs in Negotiation Leadership and Mgmt. Enroll Today!
<
http://thirdpartyoffers.juno.com/TGL3132/4c6dba9db492581fb20st02vuc>NotreDameOnline.com
<http://thirdpartyoffers.juno.com/TGL3132/4c6dba9db492581fb20st02vuc>
------------------------------------------------------------------------
_______________________________________________
List sponsored by Home Power magazine
List Address: RE-wrenches@lists.re-wrenches.org
Options & settings:
http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
List-Archive:
http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org
List rules & etiquette:
www.re-wrenches.org/etiquette.htm
Check out participant bios:
www.members.re-wrenches.org
_______________________________________________
List sponsored by Home Power magazine
List Address: RE-wrenches@lists.re-wrenches.org
Options & settings:
http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
List-Archive:
http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org
List rules & etiquette:
www.re-wrenches.org/etiquette.htm
Check out participant bios:
www.members.re-wrenches.org
Drake Chamberlin
Athens Electric
OH License 44810
CO License 3773
NABCEP TM Certified PV Installer
Office - 740-448-7328
Mobile - 740-856-9648
_______________________________________________
List sponsored by Home Power magazine
List Address: RE-wrenches@lists.re-wrenches.org
Options & settings:
http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
List-Archive:
http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org
List rules & etiquette:
www.re-wrenches.org/etiquette.htm
Check out participant bios:
www.members.re-wrenches.org
Drake Chamberlin
Athens Electric
OH License 44810
CO License 3773
NABCEP TM Certified PV Installer
Office - 740-448-7328
Mobile - 740-856-9648
_______________________________________________
List sponsored by Home Power magazine
List Address: RE-wrenches@lists.re-wrenches.org
Options & settings:
http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
List-Archive: http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org
List rules & etiquette:
www.re-wrenches.org/etiquette.htm
Check out participant bios:
www.members.re-wrenches.org
