One method of installing PV on tile (any type) is to remove the tile
and install a rolled roof material under the array area. Then
reinstall tile up to the edges of the array. The array is lowered and
framed by the tile and allows for simple installation. It looks good
too.
Kindest Regards,
Larry Crutcher
Starlight Solar
11279 S. Glenwood Ave #11114
Yuma, AZ 85367
(928) 941-1660
[EMAIL PROTECTED]
www.starlightsolar.com
Retail Store: 2998 Shari, Yuma, AZ
Renewable Energy Products, Service and Installation
On Dec 7, 2008, at 9:09 PM, Kelly Keilwitz, Whidbey Sun & Wind wrote:
Hi All,
Anyone use the Quick-Mount PV system for tile? We don't do many tile
roofs,
but we have an upcoming job with flat cement tiles. In the past
we've pulled
the tiles, placed posts and flashed, cutting the tile to fit. It's a
pain.
The Quick Mount PV system, www.quickmountpv.com, replaces a tile
with a
exact-fit plastic flashing with integral flange that goes over the
post. It
sounds like it'll save a lot of time - if it works.
Thanks,
-Kelly
Kelly Keilwitz, P.E.
Whidbey Sun & Wind, LLC
Renewable Energy Systems
NABCEP Certified PV Installer
987 Wanamaker Rd,
Coupeville, WA 98239
PH & FAX 360-678-7131
[EMAIL PROTECTED]
_______________________________________________
List sponsored by Home Power magazine
List Address: RE-wrenches@lists.re-wrenches.org
Options & settings:
http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
List-Archive: http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org
List rules & etiquette:
www.re-wrenches.org/etiquette.htm
Check out participant bios:
www.members.re-wrenches.org
_______________________________________________
List sponsored by Home Power magazine
List Address: RE-wrenches@lists.re-wrenches.org
Options & settings:
http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
List-Archive: http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org
List rules & etiquette:
www.re-wrenches.org/etiquette.htm
Check out participant bios:
www.members.re-wrenches.org
