looking good! can i ask why did you remove the supports in the mid section  
along the sides? i would have thought they would have been needed the most 
vs  the ones still in the corners.
 
how well does the resin soak into and bond to the paper mache?
 
chris
 
 
In a message dated 3/30/2014 4:51:38 P.M. Eastern Daylight Time,  
[email protected] writes:

I have been making progress with my Fox turret.  
I cut out the simple flat shapes and masking taped them together  . 
Next I fixed temporary separating blocks that can bee seen in the four  
corners.
then I cut "ribs" following the shape of the turret + 1 inch and glued it  
front and back with a spacer device to hold the rib dead center.
Good old fashioned paper mache forms the complex oval shape. 
Next I`ll glass over the shape and I`ll have a very light weight and  quite 
sturdy turret. 


Mint !!


Neil R

-- 
-- 
You are currently subscribed to the "R/C Tank Combat"  group.
To post a message, send email to [email protected]
To  unsubscribe, send email to [email protected]
Visit  the group at http://groups.google.com/group/rctankcombat

---  
You received this message because you are subscribed to the Google Groups  
"R/C Tank Combat" group.
To unsubscribe from this group and stop receiving  emails from it, send an 
email to [email protected]_ 
(mailto:[email protected]) .
For  more options, visit https://groups.google.com/d/optout.

-- 
-- 
You are currently subscribed to the "R/C Tank Combat" group.
To post a message, send email to [email protected]
To unsubscribe, send email to [email protected]
Visit the group at http://groups.google.com/group/rctankcombat

--- 
You received this message because you are subscribed to the Google Groups "R/C 
Tank Combat" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to [email protected].
For more options, visit https://groups.google.com/d/optout.

Reply via email to