How will you be doing the reduction?

________________________________
 From: TyngTech <[email protected]>
To: [email protected] 
Sent: Wednesday, February 6, 2013 11:56 AM
Subject: Re: [TANKS] Tank Fest 2
 

That is the motor and gearbox out of a Harbor Freight 18V cordless saw.  I'll 
be using two of them in the T-70 Project Extreme.  The gearbox is all ball 
bearing with steel helical cut gears.  The motor has a ball bearing on the 
pinion end.  The calculated output of the assembly is 4,629 RPM and 38.27 lb/in 
stall torque.  I'm planning an additional 9:1 reduction in the T-70 which 
equates to around 357 lb/in stall at the drive wheel.


If the motor doesn't work out, it would be easy to mount a different motor to 
the gearbox such a brushless outrunner (insane torque).


ST


On Wednesday, February 6, 2013 1:00:18 AM UTC-5, [email protected] wrote:
what is that shiny, geared motor?
> 
>Chris
-- 
-- 
You are currently subscribed to the "R/C Tank Combat" group.
To post a message, send email to [email protected]
To unsubscribe, send email to [email protected]
Visit the group at http://groups.google.com/group/rctankcombat
 
--- 
You received this message because you are subscribed to the Google Groups "R/C 
Tank Combat" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to [email protected].
For more options, visit https://groups.google.com/groups/opt_out.

-- 
-- 
You are currently subscribed to the "R/C Tank Combat" group.
To post a message, send email to [email protected]
To unsubscribe, send email to [email protected]
Visit the group at http://groups.google.com/group/rctankcombat

--- 
You received this message because you are subscribed to the Google Groups "R/C 
Tank Combat" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to [email protected].
For more options, visit https://groups.google.com/groups/opt_out.


Reply via email to