The 1/4"-20 screws go through the L-brackets into holes threaded into a 
1/2" shaft that carries the UHMW pulleys.

There isn't a lot of tension needed when the transmission is operating in 
forward mode as the tension pulleys are on the "slack" side of the belt 
loop.  This design allows me to have fixed axles and compensate for the 
belt loop length (which is unlikely to be perfect since an integral number 
of links are required and may change over time due to wear, temperature, 
etc).

If the brackets bend I can add a steel strip across the top of them, and/or 
use longer screws butted against the hull floor as you suggest (thanks!).


On Monday, September 17, 2012 12:50:27 PM UTC-4, TyngTech wrote:
>
> ...
> I can't tell from the pic but are the tensioner screws pulling up on the 
> tension pulley shaft or do they extend through the shaft and push down on 
> the bottom of the hull?  If pulling up, I'm afraid those top brackets will 
> bend under the force you will need to get adequate tension.
> ...
>

-- 
You are currently subscribed to the "R/C Tank Combat" group.
To post a message, send email to [email protected]
To unsubscribe, send email to [email protected]
Visit the group at http://groups.google.com/group/rctankcombat

Reply via email to