Some caveats....

  * You are welcome to use the documents with the realization that you
accept 100% of the risk and responsibility for doing so. The author
assumes no liability of any sort. These are NOT intended as a
comprehensive guide to building a 1/6th scale r/c paintball tank.
Checking the accuracy is up to you.

  * The document labeled "An alternative idea for road wheel bearing
mount and suspension" is an idea for using two self-centering bearings
mounted to the inside and outside of the hull wall with no internal
rail mount for the inside bearing. This will put a sh*tload of strain
on the hull wall and should only be considered if YOU build the hull
strong enough to support this.

  * There is virtually no mention of construction material or a parts
list. That would be entirely up to the would-be builder.

  * Suggestions welcome but don't take it personally if I don't act on
it. It's not you. I'm just busy with my life.

  * Criticisms should be written down in ink on paper, folded neatly
into a one inch square and swallowed whole and this too shall
pass. :-)

Cheers,
Fred

-- 
You are currently subscribed to the "R/C Tank Combat" group.
To post a message, send email to [email protected]
To unsubscribe, send email to [email protected]
Visit the group at http://groups.google.com/group/rctankcombat

Reply via email to