Oh shut up! I'm jealous enough of your equipment without you telling me 
stuff like that!

On Tuesday, 3 July 2012 22:18:23 UTC+1, Grant Stonnell wrote:
>
> Hi
> I have done a little bit of stress testing to make sure it will hold up.
> at both ends of the travel the rack ether hits the casing or the spring 
> comes under full compression, as well as that if you look closely at the 
> pinion you will see it has little lumps on the side of the rounds, this is 
> to stop the end of travel causing extra stress on the last tooth on each 
> end.
> I have tested it with about 5-600 full movements but i have also done some 
> testing with extream forces, eg i got a 6lb hammer and hit the crap out of 
> the end of the trailing arms, this bent the trailing arms but the R&P teeth 
> held up fine. :)
> At the end of the day if they do fail its only 1 min of cutting to make a 
> new pinion out of 10mm Aluminium and about 2.3mins to make it from 10mm 
> Stainless Steel or the like :)
>  
> Grant
>  
>
> On Wednesday, July 4, 2012 12:56:30 AM UTC+12, TyngTech wrote:
>
>> Grant,
>>
>> Impressive work on your Abrams and horizontal springing solution.  Have 
>> you had a chance to stress test the rack and pinion setup?  I'd be 
>> interested to see how well that first pinion tooth holds up after a couple 
>> thousand cycles.
>>
>> Again, nice work.
>>
>> Steve Tyng
>>   
>>
>> On Friday, June 29, 2012 2:30:08 AM UTC-4, Grant Stonnell wrote:
>>>
>>> Hi guys, have just found you and i am part way through a build so i 
>>> thought i would put a link up to me project for your comments
>>> Havea look at http://spudnik1970.blogspot.co.nz/
>>> Any comments or ideas would be greatfully accepted.
>>>  
>>> Grant
>>>
>>

-- 
You are currently subscribed to the "R/C Tank Combat" group.
To post a message, send email to [email protected]
To unsubscribe, send email to [email protected]
Visit the group at http://groups.google.com/group/rctankcombat

Reply via email to