Hi Gernot, There was an earlier discussion on alternative installs for Mark's Rack (including your question on struts to dropout eyelets): https://groups.google.com/d/topic/rbw-owners-bunch/5waTg7bA4co/discussion
I'd just try it out either way. Attaching both struts to the outside eyelet (like Miesha's) is a simpler installation than one strut inside, the other outside. I don't think it will make it more rigid/sturdy, but maybe someone's tried it and can chime in. If the intended use if for >> 4.4lbs, you may want to consider a different rack (like Nitto Front Rack, porteur rack, Paul's Rack, etc.). On Monday, February 25, 2013 10:33:27 AM UTC-5, Earl Grey wrote: > > Since my wife carries a lot more than 4.4lbs in the Wald zip-tied to her > Mark's, I'd like to add two extra struts from the back eyelets on the rack > to the mid-fork braze-ons. I don't have the extra two struts that the > Mark's came with, so I was going to order two 16.5cm bent Nitto struts from > Riv (I know I need to order the nuts, too). But looking at a couple of > photos of Riv staff bikes (Miesha and Brian), I notice that they used 4 > straight struts and attached them both to the outside of the hourglass > mounts on the fork. I was imagining attaching the bent struts to the inside > part of the hourglass mounts, and would think that might be marginally more > rigid/sturdy. > > Any reason why I shouldn't? Is there not enough room for brake clearance > (Tektro 559s)? Does it look ugly? Any other thoughts? What about using the > two short straight struts on the rack's rear eyelets, and getting two long > straight struts to connect to the dropout eyelets? Has anyone done that? Do > you like it? Is it sturdier? > > I know I should just call Riv, but it's too early there, and too late here > (Thailand) to stay up another 2 hours. > > Thanks! > > Gernot > > -- You received this message because you are subscribed to the Google Groups "RBW Owners Bunch" group. To unsubscribe from this group and stop receiving emails from it, send an email to rbw-owners-bunch+unsubscr...@googlegroups.com. To post to this group, send email to rbw-owners-bunch@googlegroups.com. Visit this group at http://groups.google.com/group/rbw-owners-bunch?hl=en. For more options, visit https://groups.google.com/groups/opt_out.
