My girlfriend's rear bar end was loose today on her new blue Sam that I built up a few weeks ago. I took the shifter apart so as to tighten it, and put it back together. I made absolutely no changes except to take off the electrical tape that was holding the cable housing in place, and putting it back (we never wrapped her m'stache bars because we weren't sure she would like them, which she doesn't so we're going to Alba's). Anyway, uppon reassembly, now the indexing doesn't work right.There are only about four (it's an 8-speed shifter) clicks and the rest, in the middle, don't seem to engage. The shifts that do click will skip cogs. I turn it over to friction and it seems to work fine. I'm relatively certain that the large, silver, plastic washer is in the right place, since the notch won't really allow it to be wrong. Anyone have any insight on what I might or might not have done. I tried tightening and loosening the screw but it didn't seem to make any difference. Thanks.
-- You received this message because you are subscribed to the Google Groups "RBW Owners Bunch" group. To view this discussion on the web visit https://groups.google.com/d/msg/rbw-owners-bunch/-/Afjfqato49IJ. To post to this group, send email to rbw-owners-bunch@googlegroups.com. To unsubscribe from this group, send email to rbw-owners-bunch+unsubscr...@googlegroups.com. For more options, visit this group at http://groups.google.com/group/rbw-owners-bunch?hl=en.
