... The guide position shown on my bike is correct, because that's the one that routes the front derailleur cable properly. I guess if I was using a rear derailleur only, I could have moved mine - but it still would have rubbed on the kickstand plate.
(But "yes," I did try the other hole. ) Laing On Wednesday, January 18, 2023 at 12:02:38 PM UTC-5 iamkeith wrote: Here's what I did. (this is on my Susie Longbolts, but same thing). This is a piece of 1/2" thick HDPE sheet. I really did this to kick the cable outward a little, in order to clear some really wide 2.8" tires and, now, fenders. But it had the bonus of "lifting" the cable away from the turned--down edge of the bracket, too. If you don't need the width clearance, you could also just use a small piece of cable housing liner tube. I do that often because, like you, I don't like the idea of cables rubbing on the frame. You just have to check it every few years to make sure it hasn't worn through. On Wednesday, January 18, 2023 at 9:46:00 AM UTC-7 lconley wrote: Which hole in the under BB cable guide are you using? Pictures are always helpful. Laing On Wednesday, January 18, 2023 at 10:48:02 AM UTC-5 Scott wrote: Gus owners, When doing a trial run of my RD/shifter cable from the BB cable guide to chain stay housing stop, it contacts underside of the kickstand bracket. Not proper in my mind. If you have same situation, how are you going to correct it, or just leave it? What say you? Scott -- You received this message because you are subscribed to the Google Groups "RBW Owners Bunch" group. To unsubscribe from this group and stop receiving emails from it, send an email to rbw-owners-bunch+unsubscr...@googlegroups.com. To view this discussion on the web visit https://groups.google.com/d/msgid/rbw-owners-bunch/5d685952-2b93-42d0-b58d-2da80a7c764an%40googlegroups.com.
