The coating is both a gift and a curse. Provides a nice finish/doesn't wear very nicely!
On Tuesday, May 8, 2018 at 8:32:46 AM UTC-7, lconley wrote: > > You need some snap ring spreaders: > > > <https://lh3.googleusercontent.com/-lkg1qhGhYZY/WvHB-vuvKuI/AAAAAAAAAOI/FpRSakkOoKAxgfzBnA2jBLTWbZYJG2I8gCLcBGAs/s1600/POJ_577-250G.jpg> > > You remove the bolt and gently spread the handlebar clamp of the stem > enough to insert the shims. They are also good for helping to get the stem > around tight curves in the handlebars. > > Laing > Cocoa FL > > > On Tuesday, May 8, 2018 at 11:14:53 AM UTC-4, Conway Bennett wrote: > >> I'm putting some Sim Works Getaround bars on my QB and ran into an >> interesting issue. The bars are listed as 25.4 clamp diameter and I'm >> using a 26.0 Tallux I had shimmed to run Albatross bars. No way the shims >> will fit with the getaround bars and the clamping seems good w/out them. >> On the SW site it reads: >> >> "Skid proof and clear coating are applied as a final treatment on this >> item and the actual size is wider than the diameter on the each size >> description. Please be aware of the installation of the stem, levers, and >> lock-type grips which have very severe inner diameter." >> >> Is there .6 mm of clear coat? Also they are not "skid" (scratch proof?). >> The levers scratched the clear coat when installing the grips. >> >> >> Fair winds, >> >> Captain Conway >> www.ChicaGoByBoat.com >> 833.312.BOAT >> @svnightswimming >> >> -- You received this message because you are subscribed to the Google Groups "RBW Owners Bunch" group. To unsubscribe from this group and stop receiving emails from it, send an email to rbw-owners-bunch+unsubscr...@googlegroups.com. To post to this group, send email to rbw-owners-bunch@googlegroups.com. Visit this group at https://groups.google.com/group/rbw-owners-bunch. For more options, visit https://groups.google.com/d/optout.
