somehow we got separated from the original post. im going to see if i can merge these. i am hoping it's just an angle of cut thing. i did swap in a shorter bolt that seems to fit fine.
ive had the hunqapillar for about a year and it has only ever had this one technomic stem in it that was down/in as far as it would go (short top tube+long steerer on the 54cm). i assume it was bottoming out on the butted section of the steerer, and i wanted the bars a little lower, so the thought was to cut down the stem. out of curiosity, i put a short, old sr stem in. it doesnt fully tighten either. then out of more curiosity, i pulled my girlfriend's cockpit off-featuring an technomic stem just like the one i just cut an inch off of -and it bottoms out as mine used to and fully tightens fine. so i have an cut technomic that doesnt go all the way down-wont get tight a short sr that doesnt go all the way down-wont get tight and a technomic that bottoms out-will get tight. do i need this to be bottoming out to get adequate snugness? that doesnt seem right. i dont think ive bulged anything, because, as i said, the og technomic was down low from the beginning. also im using about a 4 inch long allen key. -- You received this message because you are subscribed to the Google Groups "RBW Owners Bunch" group. To unsubscribe from this group and stop receiving emails from it, send an email to rbw-owners-bunch+unsubscr...@googlegroups.com. To post to this group, send email to rbw-owners-bunch@googlegroups.com. Visit this group at http://groups.google.com/group/rbw-owners-bunch. For more options, visit https://groups.google.com/d/optout.
