Thanks!!!!! I thought expand was already set to c(0,0) when not specifying it.
I agree I must be careful with the space left, but if a scale starts on 0, it becomes somewhat strange to see the axis start somewhere on negatives... This is my problem. Normally the issue with extra space will arise on the top and right-side of the plots, not on the bottom or left side where the axes cross. But maybe there is another way to get this... Any hints? Thanks again, Pedro At 16:40 2007/11/02, you wrote: >Hi Pedro, > >You need to set the expand parameter to c(0,0) : > >scale_y_continuous(limits=c(0,10), expand = c(0,0)) > >ggplot uses expand_range internally to ensure that you always have >some space between the data and the margins (and you should make sure >this happens in your plot too - otherwise it can be hard to see data >points on the sides) > >Hadley > >On 11/1/07, Pedro de Barros <[EMAIL PROTECTED]> wrote: > > Dear UserRs, > > > > I am trying to use systematically ggplot2 for most of my plots, but I > > am fighting some lack of documentation, which I try to overcome. > > > > I want to build a scatterplot where the axes cross exactly at (0,0). > > I tried using scale_y_continuous(limits=c(0,10)), but I always get an > > extra space at the bottom of the axes. The code I used is below. > > > > > plotdata<-data.frame(x=1:10, y=runif(10)) > > > plot<-ggplot() > > > plot<-plot+layer(data=plotdata, mapping=aes_string(x='x',y='y'), > > geom='point', stat='identity', size=4) > > > plot<-plot+ scale_y_continuous(limits=c(0,1)) > > > print(plot) > > > > I believe there may be a way to use expand_range to fix this (I think > > I read about it somewhere), but I do not seem to find out how. > > I have searched the ggplot help and > > the archives, but cannot find the answer to this issue. > > I would really appreciate if anyone could give me a pointer. > > > > I am using R2.6.0 (patched) on Windows > > > > Thanks, > > Pedro > > > > ______________________________________________ > > R-help@r-project.org mailing list > > https://stat.ethz.ch/mailman/listinfo/r-help > > PLEASE do read the posting guide > http://www.R-project.org/posting-guide.html > > and provide commented, minimal, self-contained, reproducible code. > > > > >-- >http://had.co.nz/ ______________________________________________ R-help@r-project.org mailing list https://stat.ethz.ch/mailman/listinfo/r-help PLEASE do read the posting guide http://www.R-project.org/posting-guide.html and provide commented, minimal, self-contained, reproducible code.
