On Wed, 11 Jan 2006, Mike Schaffer wrote:
> I've tried many things, so it's time to call on the gurus. I'm
> trying to make a plot that will conform to the width of the plot
> device but have a fixed height (say one inch regardless of the plot
> device height setting -- unless obviously it's less than the plot
> device).
>
> Is this possible?
Yes. Set par(pin=c(par("pin")[1], 1)).
Warning: you may not have meant the plot height, rather the figure height.
See R-Intro for the differences.
> Additionally, I'd like to be able to plot something immediately after
> this plot and have it right below. Would this require a par(mfrow=c
> ()) command? Can anyone help?
Using par(plt=) will do this for you. Or look into grid, layout or
split.screen.
--
Brian D. Ripley, [EMAIL PROTECTED]
Professor of Applied Statistics, http://www.stats.ox.ac.uk/~ripley/
University of Oxford, Tel: +44 1865 272861 (self)
1 South Parks Road, +44 1865 272866 (PA)
Oxford OX1 3TG, UK Fax: +44 1865 272595
______________________________________________
R-devel@r-project.org mailing list
https://stat.ethz.ch/mailman/listinfo/r-devel
