Thanks! I'll try the yum installation, it would be much more convenient if it works.
Perhaps a stupid question, but I found different links in the mailing list archive and I'd rather not make a mistake - where is the QMT repo? I have http://qtp.qmailtoaster.com/repos/nodist active and I can enable http://qtp.qmailtoaster.com/repos/centos/$releasever/$basearch, will that do the trick or where can I find the .repo-file? -Erik ________________________________________ From: Eric Shubert <[email protected]> Sent: Friday, June 20, 2014 5:40 PM To: [email protected] Subject: [qmailtoaster] Re: Problem with qtp-newmodel on CentOS 5.10 While qtp-newmodel is being deprecated, it still should work for *-toaster packages. dkms-fuse is no longer needed, so that's not a problem. I think your fuse-unionfs package may be a problem. I have: [root@mail ~]# rpm -qa | grep fuse fuse-unionfs-0.23-2.qtp fuse-2.8.0-1.qtp [root@mail ~]# You appear to have picked up this package from .rf instead of .qtp. I just updated clamav-toaster-0.98.4-1.4.8 on 2 hosts using qtp-newmodel and it worked ok. These are COS 5.6 and 5.8 hosts though, so that could be an issue, but I wouldn't expect it to be. Would anyone else on COS 5.10 care to try updating clamav-toaster with qtp-newmodel? Thanks. P.S. If you'd rather not mess with qtp-newmodel, you can find binary packages for clamav-toaster in the QMT repo. You can update manually with rpm, or set up a yum repo file and use yum to do the update. -- -Eric 'shubes' On 06/20/2014 12:16 AM, [email protected] wrote: > I am running qmail on CentOS 5.10. The present installation is fairly > recent. I installed with > http://www.qmailtoaster.com/centos/cnt50/cnt50-install-script.sh, which is > what I have done at least three times before, and restored a backup with > qtp-restore. There were no problems and the mail server has been running > without issues since then. > > Now qtp-amiuptodate reports that there is a new clamav package available, > so I tried qtp-newmodel. Unfortunately it fails. > > The first sign of failure is: > > No package dkms-fuse available. > Resolving Dependencies > --> Running transaction check > ---> Package fuse-unionfs.i386 0:0.23-1.el5.rf set to be updated > ... > Installed: > fuse-unionfs.i386 0:0.23-1.el5.rf > > ... > > Then the build fails with: > > mv: cannot create regular file `/mnt/qtp-sandbox/etc/mtab': Software > caused connection abort > /usr/sbin/qtp-mount-sandbox: line 172: /mnt/qtp-sandbox/boot/.qtp-sandbox: > Software caused connection abort > qtp-mount-sandbox: sandbox mounted successfully > cat: /mnt/qtp-sandbox/boot/.qtp-sandbox: Transport endpoint is not connected > > I have tried a few times with a reboot in between and yum reports all > packages up to date. > > Is this a known issue? Thanks in advance for any pointers! > > -Erik > > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [email protected] > For additional commands, e-mail: [email protected] > > --------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected] --------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected]
