On 7/14/23 16:46, Peter Maydell wrote:
In S1_ptw_translate() we set up the ARMMMUFaultInfo if the attempt to
translate the page descriptor address into a physical address fails.
This used to only be possible if we are doing a stage 2 ptw for that
descriptor address, and so the code always sets fi->stage2 and
fi->s1ptw to true. However, with FEAT_RME it is also possible for
the lookup of the page descriptor address to fail because of a
Granule Protection Check fault. These should not be reported as
stage 2, otherwise arm_deliver_fault() will incorrectly set
HPFAR_EL2. Similarly the s1ptw bit should only be set for stage 2
faults on stage 1 translation table walks, i.e. not for GPC faults.
Add a comment to the the other place where we might detect a
stage2-fault-on-stage-1-ptw, in arm_casq_ptw(), noting why we know in
that case that it must really be a stage 2 fault and not a GPC fault.
Signed-off-by: Peter Maydell<peter.mayd...@linaro.org>
---
target/arm/ptw.c | 10 ++++++++--
1 file changed, 8 insertions(+), 2 deletions(-)
Reviewed-by: Richard Henderson <richard.hender...@linaro.org>
r~
