Hi --
I ran into a problem running the qemu-0.15 and I was told
that the problem was fixed in the 1.0 release candidate.
I don't find a package with the RC on http://wiki.qemu.org/Download,
so I cloned the git repo and tried to build qemu.
I didn't find any instructions on how to build qemu on the wiki,
so I winged it with the following configure:
configure \
--enable-sdl \
--enable-curses \
--enable-curl \
--enable-kvm \
--enable-nptl \
--enable-uuid \
--enable-linux-aio \
--enable-io-thread \
--enable-debug
Is this correct, or is there a better set of options?
When I run make, there are a number of compiles which fail because
of variables being set but not used. I've modified the code to
eliminate some of them to allow the build to continue. Is there
a simpler way around this?
After getting past these issues, libhw32/serial.o is not being built:
make[1]: *** No rule to make target `../libhw32/serial.o', needed by `qemu'.
Stop.
make[1]: Leaving directory `/local/eager/source/qemu/build/i386-softmmu'
make: *** [subdir-i386-softmmu] Error
Is there a fix for this problem?
--
Michael Eager ea...@eagercon.com
1960 Park Blvd., Palo Alto, CA 94306 650-325-8077
