Hi Francisco,
On Fri, Dec 4, 2020 at 6:46 PM Francisco Iglesias
<frasse.igles...@gmail.com> wrote:
>
> Hello Bin,
>
> On [2020 Dec 04] Fri 15:52:12, Bin Meng wrote:
> > Hi Francisco,
> >
> > On Thu, Dec 3, 2020 at 4:38 PM Francisco Iglesias
> > <frasse.igles...@gmail.com> wrote:
> > >
> > > Hi Bin and Alistair,
> > >
> > > On [2020 Dec 02] Wed 11:40:11, Alistair Francis wrote:
> > > > On Sun, Nov 29, 2020 at 6:55 PM Bin Meng <bmeng...@gmail.com> wrote:
> > > > >
> > > > > From: Bin Meng <bin.m...@windriver.com>
> > > > >
> > > > > SST flashes require a dummy byte after the address bits.
> > > > >
> > > > > Signed-off-by: Bin Meng <bin.m...@windriver.com>
> > > >
> > > > I couldn't find a datasheet that says this... But the actual code
> > > > change looks fine, so:
> > > >
> > > > Acked-by: Alistair Francis <alistair.fran...@wdc.com>
> > > >
> > > > Alistair
> > > >
> > > > > ---
> > > > >
> > > > > hw/block/m25p80.c | 3 +++
> > > > > 1 file changed, 3 insertions(+)
> > > > >
> > > > > diff --git a/hw/block/m25p80.c b/hw/block/m25p80.c
> > > > > index 483925f..9b36762 100644
> > > > > --- a/hw/block/m25p80.c
> > > > > +++ b/hw/block/m25p80.c
> > > > > @@ -825,6 +825,9 @@ static void decode_fast_read_cmd(Flash *s)
> > > > > s->needed_bytes = get_addr_length(s);
> > > > > switch (get_man(s)) {
> > > > > /* Dummy cycles - modeled with bytes writes instead of bits */
> > > > > + case MAN_SST:
> > > > > + s->needed_bytes += 1;
> > >
> > > 1 dummy clk cycle is modelled as 1 byte write (see the comment above), so
> > > 1
> > > dummy byte (8 dummy clk cycles) will need +8 above.
> >
> > I think you were confused by the WINBOND codes. The comments are
> > correct. It is modeled with bytes instead of bits, so we should +=1.
>
> What the comment says is (perhaps not superclear) that 1 dummy clock cycle
> is modeled as one 1 byte write into the flash (meaining that 8 byte writes
> are needed for 1 dummy byte). Perhaps it is easier to understand
> looking into how the controllers issue the command towards the flash model
> (for example the xilinx_spips), the start of the FAST_READ cmd is issued
> as writing the following into the flash: 1 byte (cmd), 3 bytes (address),
> 8 bytes (8 dummy cycles -> 1 dummy byte).
>
My interpretation of the comments are opposite: one cycle is a bit,
but we are not using bits, instead we are using bytes.
Testing shows that +=1 is the correct way with the imx_spi controller,
and with my SiFive SPI model in my local tree (not upstreamed yet)
Regards,
Bin
