Currently, rtas_ibm_change_msi() always returns four values even if
less are specified.
Correct this by only returning the fourth parameter if it was
requested.
This is specified by PAPR.
Signed-off-by: Sam Bobroff <sam.bobr...@au1.ibm.com>
---
hw/ppc/spapr_pci.c | 4 +++-
1 file changed, 3 insertions(+), 1 deletion(-)
diff --git a/hw/ppc/spapr_pci.c b/hw/ppc/spapr_pci.c
index 05f4fac..f422e3b 100644
--- a/hw/ppc/spapr_pci.c
+++ b/hw/ppc/spapr_pci.c
@@ -360,7 +360,9 @@ out:
rtas_st(rets, 0, RTAS_OUT_SUCCESS);
rtas_st(rets, 1, req_num);
rtas_st(rets, 2, ++seq_num);
- rtas_st(rets, 3, ret_intr_type);
+ if (nret > 3) {
+ rtas_st(rets, 3, ret_intr_type);
+ }
trace_spapr_pci_rtas_ibm_change_msi(config_addr, func, req_num, irq);
}
--
2.1.4
