In late May of 2011, Brian Vandenberg queried this group about failures
he was having trying to install Solaris 8 SPARC 02/04 on a Qemu VM. The
interaction seemed to have ended with Blue Swirl indicating that Brian
should run with "-d in_ascm,int" and that the debug output would likely
be useful near the end of the output. I did searches on the mailing list
from Brian's name but did not find another thread where his original was
followed up on.
Recently and without knowledge of the above, I began trying to to
install Solaris 8 SPARC 10/01 into a Qemu VM using the git head (as of
10/25/2014) and openBIOS r1321. After struggling for a while, I found
that the installations were failing during install when java was called
to create the sysidcfg file. The error I am seeing is much like some of
those posted in May 2011 by Brian V.
I am running with the following command line options:
qemu-system-sparc \
-bios openbios-builtin-sparc32.elf \
-hda test.disk \
-cdrom Solaris8Install.iso \
-prom-env 'auto-boot?=false' -m 256 -nographic
The hard drive is a qcow2 image formatted using Solaris 8 install CD
(booted Qemu in single user mode from CD) 'format' command to create a
36G Solaris disk.
The initial format and software load appears to work without problem.
Then after reboot using the hard disk to boot, "Web Start Solaris
Command Line installation" comes up and says that it will ask about
system identification information (Network, Name Service, Date and Time,
etc.). It tells me to "Press Return to continue". I hit return and am
greeted with:
/sbin/disk0_install[60]: 125 Abort(coredump)
Looking at the /tmp/disk0_install.log file shows that there was a fault
during execution of "java sysid -nodisplay".
The message from java in the install log was:
signal fault in critical section
signal number: 11, signal code: 1, fault address: 0xeac30000, pc:
0xef2cd448, sp: 0xeb232c58
libthread panic: fault in libthread critical section : dumping core
stacktrace:
ef2cd43c
ef2cf0d4
ef2c8d98
0
I created a debug log as suggested by Blue Swirl in his response to
Brian V. in May 2011. I am able to find in the file where there is a
Data Access Fault when the pc is at the above noted location. However, I
am uncertain what to do with this information. Is this something where I
should take a couple of hundred lines of the logfile before the above pc
and Data Access Fault and include it here? Is there is an RTFM I missed?
If so, oops, sorry (maybe just point me where I should go?).
Respectfully,
Paul W.
