On 21/06/12 22:19, Andreas Färber wrote:
> Am 21.06.2012 13:21, schrieb Alexey Kardashevskiy:
>> On 21/06/12 20:36, Andreas Färber wrote:
>>> Am 21.06.2012 05:22, schrieb Alexey Kardashevskiy:
>>>> I am trying to compile the very last qemu with vfio_pci enabled. VFIO_PCI
>>>> is added as below:
>>>>
>>>> ./configure:
>>>>
>>>> case "$target_arch2" in
>>>> i386|x86_64|ppc64)
>>>> if test "$vfio_pci" = "yes" -a "$target_softmmu" = "yes" ; then
>>>> echo "CONFIG_VFIO_PCI=y" >> $config_target_mak
>>>> fi
>>>> esac
>>>>
>>>>
>>>> ./Makefile.target:
>>>>
>>>> # VFIO PCI device assignment
>>>> obj-$(CONFIG_VFIO_PCI) += vfio_pci.o
>>>>
>>>>
>>>> And it worked before. However it does not anymore as it seems that
>>>> everything in hw/ (and vfio_pci.c
>>>> as well as is in hw/ and it is a device) can be only compiled via
>>>> hw/Makefile.objs and
>>>> hw/ppc/Makefile.objs (my platform is POWER), it is ignored if to keep it
>>>> as is.
>>>>
>>>> So I have to move "obj-$(CONFIG_VFIO_PCI) += vfio_pci.o" to
>>>> hw/Makefile.objs (and change obj- to
>>>> hw-obj-) but the hw/Makefile.objs does not include (directly or
>>>> indirectly) generated
>>>> ppc64-softmmu/config-target.mak with CONFIG_VFIO_PCI=y.
>>>>
>>>> What is the correct solution?
>>>
>>> If the file compiles the same for all three, put CONFIG_VFIO_PCI=y into
>>> default-configs/{i386,x86_64,ppc64}-softmmu.mak and do
>>> hw-obj-$(CONFIG_VFIO_PCI) += in hw/Makefile.objs.
>>
>>
>> It only compiles with ./configure --enable-vfio-pci which may or may not set
>> CONFIG_VFIO_PCI to "y".
>> Your proposal makes it always "y" (for selected platforms).
>
> Apply some creativity, there's surely examples around. The question is
> whether the contents of vfio_pci.o changes or not.
Applied already and gave up, this is why I am writing here :)
What would be a good example of a device which is enabled by configure script?
> If not, then you only
> need to build it once in libhwX/, depending on $config_target_mak, and
> link to the appropriate targets. If it accesses CPU internals then it
> must be built per target.
$config_target_mak points to ppc64-softmmu/config-target.mak, not in the root
folder.
When executed in libhw64, it is not visible to makefile.
>>> Otherwise, add to hw/{i386,ppc}/Makefile.objs - or with Anthony's
>>> proposal from yesterday hw/Makefile.objs becomes possible, too.
>>
>> Again, it will be unconditional "y".
>
> No, in this case the condition would be set from configure as before, it
> only moves from Makefile.target to the appropriate Makefile.objs.
> Note that to limit it to ppc64 (as opposed to ppc) some additional ifeq
> check would be needed, as before.
--
Alexey
