So, this is what I came up with. It works, which is good but it’s a little different from a few things you guys had mentioned. For one, I got the correct time by calculating the number of time run and converting that into seconds then back out to hr:mn:sc. I didn’t calculate from midnight. That seemed more complicated to me because I’d have to figure the number of seconds from midnight to 6:52am then do the calculations for number of seconds run until I got home, then I got kind of lost. Also, before I forget what is the difference between / and //? I remember somthing about floor division? Not sure what that means though. Is it like a % where it gives the remainder after dividing? Thanks again. Code below. Also, I think I found out through a little trial and error that I had two different hours, mins, and sec so I had to use one uppercase and one lower case. Is that frowned upon? And should I have come up with a different name instead?
SECONDS = 1 MINUTES = 60 * SECONDS HOURS = 60 * MINUTES time_left_house = 6 * HOURS + 52 * MINUTES miles_run_easy_pace = 2 * (8 * MINUTES + 15 * SECONDS) miles_run_fast_pace = 3 * (7 * MINUTES + 12 * SECONDS) time_returned_home = miles_run_easy_pace + miles_run_fast_pace + time_left_house hours = time_returned_home // HOURS part_hour = time_returned_home % HOURS minutes = part_hour // MINUTES seconds = part_hour % MINUTES print "Time returned home:", hours,":", minutes,":", seconds,"am" On Jan 31, 2014, at 6:51 AM, Neil Cerutti <ne...@norwich.edu> wrote: > On 2014-01-31, scottw...@gmail.com <scottw...@gmail.com> wrote: >> Here is the question that was asked and below that I'll paste >> the code I have so far. >> >> **If I leave my house at 6:52 am and run 1 mile at an easy pace >> (8:15 per mile), then 3 miles at tempo (7:12 per mile) and 1 >> mile at easy pace again, what time do I get home for >> breakfast?** > > That depends on the directions in which you run. Also, you are > fast! > > But seriously, my advice is to find the answer the old fashioned > way first, with pencil and paper. Then you'll have two things you > don't now: > > 1. A correct answer to test your program's answer with. > 2. A general idea of how to solve the problem. > > It's often a mistake to start writing code. Eventually you'll be > able to go directly from problem to code more often, but it will > take practice. > > -- > Neil Cerutti > > -- > https://mail.python.org/mailman/listinfo/python-list -- https://mail.python.org/mailman/listinfo/python-list