Hi All, I want to do verification in my scripts. So for that what i am doing here are shown below:
1. Telnet to one router. 2. Configure router. 3. Configure routing. Now after doing all these i have to check showinterfaces. So i execute command show interface and saved the output in one file. Now the problem which i am facing is how to do assertion from that output. e.g output is something like this eth0 is up OSPF not enabled on this interface eth1 is up Internet Address 192.168.1.2/24, Area 0.0.0.0 Router ID 192.168.1.2, Network Type BROADCAST, Cost: 10 Transmit Delay is 1 sec, State DR, Priority 1 Designated Router (ID) 192.168.1.2, Interface Address 192.168.1.2 No backup designated router on this network Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5 Hello due in 00:00:00 Neighbor Count is 0, Adjacent neighbor count is 0 eth2 is up OSPF not enabled on this interface eth3 is down OSPF not enabled on this interface lo is up OSPF not enabled on this interface sit0 is down OSPF not enabled on this interface In this i want to check Designated Router (ID) 192.168.1.2. If this is the same Ip which i have gice in configuration then test case will get pass otherwise Fail. Can somebody send me the code how to do this. Thanks in Advance Vikram Malhotra -- http://mail.python.org/mailman/listinfo/python-list