Hi,
I am running the latest incentive version of MacPymol and have noticed that I
am unable to render figures containing dot surfaces. If I setup the figure with
show dots and then ray, my dot surface is not visible in the ray output. I
tried increasing the dot radius incase it was simply too small but thus far no
luck.
Anyone else experienced this? Any suggestions on a work around?
Many thanks,
Colin
Manchester
Protein
Structure
Facility
Dr. Colin W. Levy
MIB G034
Tel. 0161 275 5090
Mob.07786 197 554
c.l...@manchester.ac.uk<mailto:c.l...@manchester.ac.uk>
------------------------------------------------------------------------------
Meet PCI DSS 3.0 Compliance Requirements with EventLog Analyzer
Achieve PCI DSS 3.0 Compliant Status with Out-of-the-box PCI DSS Reports
Are you Audit-Ready for PCI DSS 3.0 Compliance? Download White paper
Comply to PCI DSS 3.0 Requirement 10 and 11.5 with EventLog Analyzer
http://pubads.g.doubleclick.net/gampad/clk?id=154622311&iu=/4140/ostg.clktrk
_______________________________________________
PyMOL-users mailing list (PyMOL-users@lists.sourceforge.net)
Info Page: https://lists.sourceforge.net/lists/listinfo/pymol-users
Archives: http://www.mail-archive.com/pymol-users@lists.sourceforge.net
