On Friday, August 1, 2003, at 06:50 AM, Milton H. Werner, Ph.D. wrote:
When I ray trace with the internal renderer (default renderer), my
rendered image is not kept in stereo, but instead snaps back to mono.
How do I get stereo ray traced images.
Milton,
you must ray trace two separate images and write them out and assemble
them in Photoshop or Canvas etc
angle=3
ray
png LEFTfig
angle=-6
ray
png RIGHTfig
If you want higher res image replace 'ray' with 'ray 1200,1600' or some
other appropriate value of image width/height
remember to turn on antialiasing too.
Also, is there a way to increase the number of passes for the
anti-alias smoothing function--it seems a little low for ribbons
drawings compared to, say, Mike Carson's Ribbons program.
In the setting you can play around with ribbon quality. I forget the
exact settings, just snoop around in the settings
Good luck
Scott
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Scott Classen, Ph.D.
ACS Postdoctoral Fellow
Department of Molecular & Cell Biology
University of California, Berkeley
237 Hildebrand Hall #3206
Berkeley, CA 94720-3206
LAB 510.643.9491
FAX 510.643.9290
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
