(inline) On Thu, Jan 17, 2013 at 03:27:40PM -0600, Nan Liu wrote: > On Thu, Jan 17, 2013 at 2:59 PM, Christopher Wood > <[1]christopher_w...@pobox.com> wrote: > > The question: how can I get extra debugging/troubleshooting information > to figure out why my F5 resources aren't applying? I see my "puppet > device" command claiming to have applied an f5_node and f5_rule, but the > irule and node respectively do not appear in the device's config. > > I have already turned up logging on the F5 device and debug/verbose in > my puppet device run and found nothing obvious there. > > (More details below.) > > I see these: > > Notice: /Stage[main]//Node[my_f5]/F5_node[192.168.127.1]/ensure: created > Notice: /Stage[main]//Node[my_f5]/F5_rule[cw1]/ensure: created > > As part of this set of debug output, but: > > [cwood@lb-lab:Active] log # grep cw1 /config/bigip.conf > [cwood@lb-lab:Active] log # > > I'm not familiar with F5 tmsh, the puppet module is using iControl to > update the device, so I don't know how changes are reflected in the text > config.�
Usually when I make a change via the gui or tmsh I see the change reflected in the text config right away. > If you run puppet again does it attempt to make the same changes again? Yes, it does. > If > not the changes should have taken effect. Can you login to the web console > and review if the rules were added to the device? The changes were not applied to the device. (There is only the common partition and four nodes on the lab F5, and I was trying to add the fifth node.) > Thanks, > Nan > > -- > You received this message because you are subscribed to the Google Groups > "Puppet Users" group. > To post to this group, send email to puppet-users@googlegroups.com. > To unsubscribe from this group, send email to > puppet-users+unsubscr...@googlegroups.com. > For more options, visit this group at > http://groups.google.com/group/puppet-users?hl=en. > > References > > Visible links > 1. mailto:christopher_w...@pobox.com -- You received this message because you are subscribed to the Google Groups "Puppet Users" group. To post to this group, send email to puppet-users@googlegroups.com. To unsubscribe from this group, send email to puppet-users+unsubscr...@googlegroups.com. For more options, visit this group at http://groups.google.com/group/puppet-users?hl=en.
