Hi, Just wondering what tests exist as I would like to test my digi 003
to see what it's best settings are? Nick Gawronski
On Mon, 25 May 2015,
TheOreoMonster wrote:
Date: Mon, 25 May 2015 19:13:05 -0400
From: TheOreoMonster <[email protected]>
Reply-To: [email protected]
To: [email protected]
Subject: Re: Sample Rate
The reason i suggest starting at 44.1khz is that unless you have a high end
interface chances are your interface while capable may not perform its best at
88.2khz or 96khz. There are proven test to verify this incase you want to put
your sound card to the challenge. I assumed the person asking the question
(since they did after all ask the question) that they were relatively new and
using modes gear, so suggest an option that would get them quality results
without taxing their system,.
On May 25, 2015, at 1:38 PM, [email protected] wrote:
Hi, I usually go to 24 bit 96 KHZ the highest that Pro Tools supports with my
digi 003 as my point is I want to get the most out of my equipment. I almost
always record to an external drive unless it is just a recording I am not
planning on doing anything major with or just practice editing with. Nick
Gawronski
On Mon, 25 May 2015, Jack Ronnayut wrote:
Date: Mon, 25 May 2015 20:45:23 +0700
From: Jack Ronnayut <[email protected]>
Reply-To: [email protected]
To: ProTools Access Mailing List <[email protected]>
Subject: Sample Rate
Hi Folks,
What sample rate do you guys often use?
What is the suitable rate?
Any idea about setting it is very appreciated.
Thank you in advance for your kind answers.
Jack,
--
You received this message because you are subscribed to the Google Groups "Pro Tools
Accessibility" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
For more options, visit https://groups.google.com/d/optout.
--
I use grml (http://grml.org/)
--
I use grml (http://grml.org/)
