I now think its the network i am connecting (or not) to that's the problem and not the card.
Lorna
Michael Kuss wrote:
On Fri, 14 Mar 2003, Lorna M Stimson wrote:
Hi,
Thanks for the suggestions...
The device/driver info i just read from the hardware browser gui and hwconf.
And kudzu has already put and alias for eth0 into /etc/modules.conf for the network card driver
I used modprobe and lsmod shows the driver, and from the "/sbin/ip link" command i get a "lo" entry and an "eth0" entry. ( somthing like "eth0 <BROADCAST,MULTICAST,UP> mtu 1500 qdisc pfifo_fast qlen 100 link/ether")
Sorry i should have been more explicit... the config files i copied - i did change the ip address and hostname information. (but left the domain,DNS,netmask,gateway etc... information as on the other PC)
Are both PC's on the same network? I.e. (assuming a class C network), the first three numbers are identical? If not, you have to use a different gateway for your computer.
In general, these files are small, so you could post them here. Maybe someone notices something you don't see.
Cheers,
Michael
--
LORNA M. STIMSON
Department of Materials Science, University of Patras, 26500 Patras, Greece.
Tel: +30 2610 99 6374 Email: [EMAIL PROTECTED]
-- Psyche-list mailing list [EMAIL PROTECTED] https://listman.redhat.com/mailman/listinfo/psyche-list
