Thanks for the note. I changed this because I was getting a deprecation warning from glib. I'll fix this somehow.
On Fri, Jul 8, 2022 at 10:35 PM Friedrich Beckmann < friedrich.beckm...@gmx.de> wrote: > Hi Ben, > > the introduction of g_memdup2 breaks the compilation on debian buster > because this was introduced in a later glib2 version. > > > https://discourse.gnome.org/t/port-your-module-from-g-memdup-to-g-memdup2-now/5538 > > Buster has glib 2.58.3 while we need now 2.67.3. Maybe we should note this > in the minimum requirements. Also Debian bullseye has 2.66.8 and will > probably fail to build. > > Regards > > Fritz > > Anfang der weitergeleiteten Nachricht: > > *Von:* build...@pspp.org > *Datum:* 9. Juli 2022 um 06:48:45 MESZ > *An:* friedrich.beckm...@gmx.de > *Betreff:* *☠ Buildbot (GNU pspp CI): debian-buster-amd64 - failed > compile (failure) compile (failure) > '/home/buildbot/pspp-buildbot/get_test_results.sh > debian-buster-amd64-build' (failure) (master)* > > > > A failed build has been detected on builder debian-buster-amd64 > <https://caeis.etech.fh-augsburg.de/buildbot/#builders/5/builds/15> while > building GNU pspp CI. > > Information: > > - Build state: failed compile (failure) compile (failure) > '/home/buildbot/pspp-buildbot/get_test_results.sh > debian-buster-amd64-build' (failure) > - Revision: 93261332cde187e1392b6935234b2b1d8b9a1d51 > - Worker: hsa-worker > - Build Reason: (unknown) > - Blamelist: Ben Pfaff > > Steps: > > - 0: worker_preparation ( success ) > - 1: git ( success ) ( <stdio> > > <https://caeis.etech.fh-augsburg.de/buildbot/#builders/5/builds/15/steps/1/logs/stdio> > ) > - 2: compile ( failure ) ( <stdio> > > <https://caeis.etech.fh-augsburg.de/buildbot/#builders/5/builds/15/steps/2/logs/stdio> > <warnings > (115)> > > <https://caeis.etech.fh-augsburg.de/buildbot/#builders/5/builds/15/steps/2/logs/warnings__115_> > ) > - 3: make check ( failure ) ( <stdio> > > <https://caeis.etech.fh-augsburg.de/buildbot/#builders/5/builds/15/steps/3/logs/stdio> > ) > - 4: Test Results ( failure ) ( <stdio> > > <https://caeis.etech.fh-augsburg.de/buildbot/#builders/5/builds/15/steps/4/logs/stdio> > <testsuite.log> > > <https://caeis.etech.fh-augsburg.de/buildbot/#builders/5/builds/15/steps/4/logs/testsuite_log> > ) > - 5: shell ( success ) ( <stdio> > > <https://caeis.etech.fh-augsburg.de/buildbot/#builders/5/builds/15/steps/5/logs/stdio> > ) > - 6: shell_1 ( success ) ( <stdio> > > <https://caeis.etech.fh-augsburg.de/buildbot/#builders/5/builds/15/steps/6/logs/stdio> > ) > >
