OK; basic question: In P98 SE, how do you configure the electrical types of pins to be input/output/power/passive/unknown etc. such that in schematic you can do such things as run an ERC and find nets that don't have an output? How exactly do you initiate such an ERC? How can you override noted conditions that are really acceptable ones such that you don't have to keep rummaging through them every time?
NOTE: One of my customers masters all his schematics exclusively in Protel 98 SE using flat topology and is not about to change, so I must use it for the schematic tool in this particular case. It is not practical to convert to DXP and back for each minor change. Jeff Condit 6946 Clark Rd. Paradise, CA 95969 Office: (530) 877-6443 Cell: (530) 228-6780 [EMAIL PROTECTED] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[EMAIL PROTECTED] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
