I am using DXP +SP2 and have a PCB design where the document size is very much bigger than the board. Because of this I can't get a print preview or generate Gerber files. In the latter case I get a 'film too small' error. I don't know how the document size got changed but I would very much appreciate a way to reset it to the same as the sheet so I can make some output files. All suggestions welcome.
Regards, Dave * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[EMAIL PROTECTED] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
