Orerect. That is my oberservation as well. I used to think that a full reload was necc, but it's not.
-----Original Message----- From: Wojciech Oborski [mailto:[EMAIL PROTECTED] Sent: Thursday, July 29, 2004 8:54 AM To: Protel EDA Forum Subject: Re: [PEDA] 99SE SP6 updating footprints I may confirm the behaviour that Leo described - - after adding/removing a component to/from a library, going back to PCB Editor, clicking on a library name in Explorer Window (Browse PCB tab) - - the "Components" list is updated. It means - it works for me. Regards, Wojciech Oborski Leo Potjewijd wrote: <snip> > John, > I just did what you described: opened an existing pcb, went to the > library editor via 'edit' in the navigator, copied and renamed an > existing footprint (thus creating a new one), clicked on the save > button, stepped back to the pcb and clicked on the library name: > presto!, the new component showed up in the list.... > I even checked it with removal of components, that works too for me.... > > There is defenitely something very weird going on. > Be it in my installation, yours, or both. <snip> * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[EMAIL PROTECTED] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
