your ddb is probably ok (we hope) i have yet to have one go south try deleting all your printers and reopening it
i have never had repair do anything either good or bad i assume you have rebooted the machine somewhere along the way next try deleting or renaming the .rcs file in \winnt good luck and let us know the outcome ds [EMAIL PROTECTED] wrote: > > I have a ddb with a moderately complex schematic, and was just wrapping up an > initial parts placement today in preparation for a meeting with the client > tomorrow. I attempted to use the print preview manager to print to a PDF, but > had various snafus along the way, mostly because I was trying to rush. Now, the > preview is completely blank, and any time i attempt to open the PCB I get > "Access violation at address 028E9486 in module 'ADVPCB.DLL'. Read of address > 0000000F". I've tried turning off automatic compaction, performing a manual > compaction (which appears to succeed), and performing a Repair (which also appears > to succeed). But I'm no closer to seeing my PCB than I was several days ago. > > HELP!!!! > > Steve Hendrix > * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * -- _______________________________________________________________________ Integrated Controls, Inc. Tel: 415-647-0480 EXT 107 2851 21st Street Fax: 415-647-3003 San Francisco, CA 94110 www.integratedcontrolsinc.com * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[EMAIL PROTECTED] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
