Here is an analogy. I have a router and I want it connect Points A B C
and D on a back plane in that order. I can write three lines of code to
connect them, a forth line of code to define the layer and fifth line of
code to tell it no vias or .....I can take my mouse and manually route the
trace in 5 seconds. If I have to do this for every A B C D connection then
it cant be done with the router. Trust me , no autorouter can route a
backplane (not yet anyway ) So you tell me where the trade off is
..when I say it cant be done. Tony is right, it can be done once
I have boards where I am switching these views on a regular basis, trying to
match lengths on 32 bit busses and topology Those are typical high speed
requirements. This capability was available in 99SE with only 4 keys .
Writing code to switch views .....that translates to "it cant be done"
And yes I do know how to use the software I just dont want to program views.
Mike Reagana
---------- Original Message ----------------------------------
From: Ian Wilson <[EMAIL PROTECTED]>
Reply-To: "Protel EDA Forum" <[EMAIL PROTECTED]>
Date: Thu, 18 Mar 2004 14:16:00 +1100
>On 01:15 PM 18/03/2004, Tony Karavidas said:
>>Mike,
>>
>>It can be done. Create you net class as you did. Then, go to the List window
>>and type
>>
>>(ObjectKind = 'Net') AND (InNetClass('AD'))
>
>Or
>IsNet AND (InNetClass('AD'))
>(a bit less typing)
>Ian
>
>
>
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
