To ensure that all my vias are not exposed after fabrication (masked), is it that "Tented" should be selected under the via properties?
I am trying to created Gnd border along the perimeter of my rectangular pcb board, which should be masked (just like thick traces). If I were to use "place trace", the cornerings would be round - not what I want to achieve. It is required that the cornerings be sharp right angles.
Can I use "place Fill" or "Place Pads" to create the GND border? If so, what can I do to ensure that my GND border would not be exposed (masked like copper traces) after fabrication?
cheers...
_________________________________________________________________
Get 10mb of inbox space with MSN Hotmail Extra Storage http://join.msn.com/?pgmarket=en-sg
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[EMAIL PROTECTED] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
