IMO though, its a waste of your time because most fabricators do this as a standard procedure. Some fabricators take shortcuts though, so if you do want them to do it be sure to put such a note in your fabrication drawing.
Mark
At 12:43 PM 8/16/2003, you wrote:
Is there an automatic way to remove or prevent overlay lines from being placed on pads?
Thank you, Gary Allbee Alta Industrial Automation Ltd
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[EMAIL PROTECTED] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
