Try hiding all nets (Press 'N'ets, 'H'ide, 'A'll) Regards Nick Papas Performance Micro Systems Pty. Ltd.
-----Original Message----- From: Terry Creer [mailto:[EMAIL PROTECTED] Sent: Wednesday, 30 July 2003 09:09 To: 'Protel EDA Forum' Subject: [PEDA] Analysing... Hi all, I've just been handed a rather large board with quite a few individual GND polygons on it (35 to be exact). I've been asked to clean it up so we can have a prototype made. Every time I make a change to the board, (ie, move track, delete fill etc..etc..), after the edit, it sits there for about 6 seconds with " Analysing GND" in the status bar at the bottom, and then all is well until the next edit. I've turned off all online DRC checks, and anything else I could think of, to no avail. I'm pulling my hair out trying to get this done (and there's a lot to do...). Any ideas? Thanks! TC * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[EMAIL PROTECTED] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
