Peter, to answer your question from below, there is a way to do it.
In a top level schematic place a sheet symbol. On the sheet symbol place a bidirectional port (e.g. 12V). Connect a wire to that port and connet it to your 12V rail. On a sub-circuit place a bidirectional port of the same name (12V). Connect that port to your 12V rail on the sub-sheet. The two become the same net. Regards, Igor -----Original Message----- From: Peter W. Richards [mailto:[EMAIL PROTECTED]] Sent: Tuesday, 11 February 2003 9:25 AM To: Abd ul-Rahman Lomax Cc: Protel EDA Forum Subject: Re: [PEDA] Buses On a related Protel-sabotaging-design-reuse note, is there a way to create a sub-module and connect one of its inputs to power or ground, without getting ERC errors that claim I've shorted two nets (for example GND vs. the net name inside the subsheet?) -- Peter W. Richards / [EMAIL PROTECTED] Design Manager, EE ph +1 (408) 737 8100 x113 fx +1 (408) 737 8153 350 Potrero Av Sunnyvale, CA 94085 This email message (and any attached document) contains information from Reflectivity, Inc. which may be considered confidential by Reflectivity, or which may be privileged or otherwise exempt from disclosure under law, and is for the sole use of the individual or entity to whom it is addressed. Any other dissemination, distribution or copying of this message is strictly prohibited. If you receive this message in error, please notify me and destroy the attached message (and all attached documents) immediately. * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[email protected] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
